✨✨6000W laser cleaning machine replacing the reflective lens
📢The disassembly and assembly process needs to be carried out in a clean environment. When removing and installing the lenses, dust-free gloves or dust-free finger covers must be worn.
📌First, wipe off the dust on the motor cover.
📌Then, unscrew the fixing screws on the motor cover
📌Then remove the side cover plate.Remove the motor cover.
✨Unplug the motor wire and remove it.
✨Then remove the fixing screws of the motor.
✨After removing the motor, apply masking tape to prevent dust from entering.
✨Remove the internal hexagonal screw on the motor clamp.
💎Remove the worn-out reflective lens that needs to be replaced.
💎Then install the new reflecting lens.
🔥🔥Attention! The motor shaft and the reflecting lens need to be adjusted to the center position during installation.
💎After adjustment, tighten the internal hexagon screws on the motor clamp to secure it properly.
💎Then, carefully remove the Scotch tape and insert the motor into the gun head.Tighten the fixing screws of the motor again.
💎Finally, install the motor cover and tighten the fixing screws.
Foster Laser
+86 153 1415 5887
www.fosterlaser.com
https://www.fosterlaser.com/
